User`s guide

Monitoring capabilities from the command line
208
Commands for managing XBee networks and nodes
Several commands are used to configure XBee networks and display information and statistics
about the devices in the network: set mesh, display mesh, xbee, and info zigbee_sockets.
 The set mesh command configures XBee network settings for a ConnectPort X
gateway. Also displays current configuration parameters on the gateway mesh node or
of remote nodes in the mesh (specified by the address option).
 The display mesh command refreshes the display of XBee network devices, and
displays specific information about XBee network devices. Information displayed
includes the node address and ID list, as well as individual node status.
 The xbee command executes an XBee utility or displays the status of actions performed
by the XBee utilities. Actions include displaying information about the XBee network
setup, sending loopback data, displaying the status of XBee firmware, and scheduling
XBee firmware updates.
 The info zigbee_sockets command displays statistics about XBee device sockets and
data communications activity on an XBee network. These statistics show what is
happening on the XBee network from the ConnectPort X gateway’s perspective;
essentially data from the XBee module’s perspective as interpreted by the XBee driver
in the gateway.