User`s guide

LEDs
24
Network LED
The Network LED indicates the status of the connection of the ConnectPort X2e ZB to both a
communications network and an iDigi server. The LED can be user-controlled; see page 89 for
details.
Color and
blink
pattern
Ethernet Wi-Fi Cellular
Off No Ethernet detected.
No Wi-Fi AP or Ad-Hoc
networks detected.
No cellular network
detected.
Blinking
yellow
(slow)
Ethernet interface identified;
waiting for link.
Wi-Fi AP or Ad-Hoc
network detected.
Connecting to Wi-Fi.
Waiting for association.
Cellular network(s) detected.
Registering on cellular
network.
Blinking
yellow (fast)
Connected to Ethernet.
Establishing LAN
connection. Waiting for IP
address.
Connected to Wi-Fi.
Establishing LAN
connection. Waiting for IP
address.
Registered on cellular
network. Establishing WAN
connection. Waiting for IP
address.
Solid yellow An IP address has been
assigned to the gateway.
Connected to LAN. Waiting
for iDigi service to take
control, and for DNS
resolution of server chosen
by the iDigi service.
An IP address has been
assigned to the gateway.
Connected to LAN. Waiting
for iDigi service to take
control, and for DNS
resolution of server chosen
by the iDigi service.
An IP address has been
assigned to the gateway.
Connected to WAN. Waiting
for iDigi service to take
control, and for DNS
resolution of server chosen
by the iDigi service.
Alternating
between
yellow and
green
The gateway cannot connect to iDigi. The two most common reasons for this state are:
The gateway cannot connect to a DNS server to resolve the iDigi server address. See page 91.
The gateway cannot connect to an NTP time server to get the correct time. See page 91.
Blinking
green (slow)
Verifying Internet connection. Waiting for network connection to the chosen server.
Blinking
green (fast)
Connected to Internet. Establishing iDigi connection. Waiting for protocol level “connection”
with iDigi server, which might include authentication.
Solid green Gateway is connected to the iDigi server.