User`s guide

102
Verify device support of commands
On the configuration specific shell interface, online help is available to verify whether a
ConnectPort LTS product supports a particular command. For example:
 help displays all supported commands for a device.
 ? displays all supported commands for a device.
 set ? displays the syntax and options for the set command. Use this command to determine
whether the device includes a particular set command variant to configure various features.
 help set displays syntax and options for the set command.
 set serial ? displays the syntax and options for the set serial command.
 help set serial displays the syntax and options for the set serial command.
Here are some examples of commands used to configure the ConnectPort LTS product. See the
Introduction of the ConnectPort LTS Command Reference for a complete list of features and tasks
that can be configured and performed from the command line.
To configure:
Use this command:
alarms
set alarm
autoconnection behaviors for serial port connections
set autoconnect
Ethernet communications parameters
set Ethernet
group attributes: create or establish group attributes,
update or remove groups or group attribute
set group
host name
set host
modem emulation
set pmodem
network options
set network
network services
set service
Point-to-Point (PPP) connections
set ppp
port buffering
set buffer
port profile for a serial port
set profile