Reference Manual

About the ConnectCore® 8X Module variants
ConnectCore® 8X System-on-Module Hardware Reference Manual --
Preliminary
8
o
4x I2C: High Speed, DMA support. One of them (I2C0) is used internally in the SOM and is
not available for general purposes.
o
4x I2C: Low Speed, no DMA support.
o
1x I2C: PMIC control (dedicated).
o
1x I2C: Cortex M4F (dedicated).
l 4x SAI:
o
SAI0 and SAI1 are transmit/receive.
o
SAI2 and SAI3 are receive-only.
l 2x Quad SPI or 1x Octal SPI (FlexSPI).
l 1x SD 3.0 card interface.
l Displays:
o
2x MIPI-DSI/LDVS. For LVDS, VESA and JEIDA standards supported.
o
1x 24-bit parallel display up to WVGA.
l Cameras:
o
1x MIPI-CSI camera with 4 lanes.
o
1x 8-bit parallel CSI.
l 1x Enhanced Serial Audio Interface (ESAI).
l 2x ASRC (Asynchronous Sample Rate Converter).
l 1x SPDIF.
l MPEG-2 Transport Stream.
l 1x 12-bit, 6 channel ADC converter.
l 3.3 V/1.8 V GPIO.
l 4x PWM channels.
l 1x 4x4 KPP (Key Pad Port).
l 1x MQS (Medium Quality Sound).
l 4x SPI.
n Arm Cortex-M0+ Digi Microcontroller Assist
TM
(MCA) subsystem:
l Cortex-M0+ core operates up to 48MHz.
l Power and reset control.
l Real time clock (RTC).
l 19 general purpose IOs (GPIOs), all IRQ capable with debouncing configuration.
l 9 analog to digital converters (ADCs), all with comparator capabilities.
l Watchdog.
l Tamper detection, both digital and analog.
l 8 bytes of non volatile storage (NVRAM).
l 3 UARTs, with optional hardware handshake.
l 10 pulse width modulators (PWMs).
Module variants
See the full list of variants in the ConnectCore 8X documentation portal.