Reference Manual

Regulatory information and certifications Europe
ConnectCore® 8X System-on-Module Hardware Reference Manual --
Preliminary
111
CE labeling requirements
The CE mark shall consist of the initials CE taking the following form:
n If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n The CE marking must have a height of at least 5mm except where this is not possible on
account of the nature of the apparatus.
n The CE marking must be affixed visibly, legibly, and indelibly.
Declarations of Conformity
Digi has issued Declarations of Conformity for the ConnectCore 8X system-on-module concerning
emissions, EMC, and safety. For more information, see http://www.digi.com/resources/certifications.
Important note
Digi customers assume full responsibility for learning and meeting the required guidelines for each
country in their distribution market. Refer to the radio regulatory agency in the desired countries of
operation for more information.
Approved antennas
The same antennas have been approved for Europe as stated in the FCC table for use with the
ConnectCore 8X module.
Country list
Note This device is restricted to indoor use only when operating in the 5150-5350MHz frequency
range within all member states.