International Quick Installation Guide Ethernet Hub 910H

Install Guide
Model: MIL-910H 5
Cascading Hubs
When you 10BASE-T network needs to grow past the eight available UTP
connections provided by the hub you should consider purchasing an additional
hub and cascading it with the original hub.
The 910H features a cascade enable switch. The switch allows you to use straight
UTP cables instead of the traditional cables when cascading hubs on port 9.
The following diagram illustrates 10BASE-T cascading:
Figure 4
Wall Mounting
After you have decided on a suitable location for mounting the hub, mark the
location for mounting two screws 165mm apart. At the marked locations, drill
two holes and insert a tapping screw in each hole. Align the hub’s wall-mount
slots with the screws and slide the hub down until the screws are securely last to
the hub. You can now complete the installation procedure by marking the
necessary cable connections.
Hub 1
Hub 2
Hub 3
Hub 4
Up to 7 PCs
Up to 6 PCs
567
9
Normal Cascade
DC 7.5V
12348
567
9
Normal Cascade
DC 7.5V
12348
567
9
Normal Cascade
DC 7.5V
12348
567
9
Normal Cascade
DC 7.5V
12348
Up to 6 PCs
Up to 7 PCs