User`s guide

Update POST Code
70 Chapter 4 Configure Industrial Automation (IA)
Procedure: Configure the Serial Port for RealPort
Use this topic for information on configuring the Digi device.
1. Access the Digi device configuration from a web browser by entering
the device’s IP address in the browser’s URL window.
2. Log on to the Digi device as the root user as shown. The default
password is dbps.
3. Do one of the following:
4. Use the Add RealPort wizard and the associated help text to configure
the RealPort driver with the IP address and TCP port number used by
the device server.
5. Follow the prompts to complete configuration of the RealPort driver.
Update POST Code
This procedure shows you how to upgrade POST code from a file or TFTP.
Typically, POST upgrades are not required and should only be done if the
firmware release notes indicate that this step is required.
The preferred method is to use your web browser and download the file
onto your PC. TFTP, however, is often used in UNIX environments, so
TFTP is supported as well.
Prerequisite
This procedure assumes that:
• You have already downloaded the firmware file from the web site.
• TFTP is running (if you are using the TFTP option).
Procedure
1. Open a web browser and enter the device server’s IP address in the
URL window.
2. Log in to the device server as root. The default password is dbps.
3. Choose Upgrade Firmware from the main menu.
4. From the dropdown menu, select Boot/POST.
5. Click Browse to select the Boot/Post image.
6. Click Update.
If the slave is using a supported
serial port protocol
If the slave is not using a supported
serial port protocol
Choose Port from the main menu.
Set the Device Profile to IA.
Click Apply and enter the protocol
information.
Choose Setup Wizards > RealPort.
Use the wizard to complete
configuration.