User`s guide

DF1 Profile: Serial-Connected Master
Chapter 4 Configure Industrial Automation (IA) 61
DF1 Profile: Serial-Connected Master
When to Use
Use this profile to connect a master device using DF1 Full-Duplex and DF1
Half-Duplex protocols to the serial port.
Configuration Options
The serial port connection must be configured for the protocol required by
the master, in this case DF1 Full-Duplex or DF1 Half-Duplex. If the remote
slave supports TCP socket communication, which is the case if the remote
slave is connected to another device server, Digi recommends this option.
For DF1 Full-Duplex users, Allen Bradley Ethernet and Ethernet/IP are
other supported network options.
Setup Information
• To configure the port for DF1 Full-Duplex or DF1 Half-Duplex and the
network for TCP socket communication, see "Configure a Serial-
Connected Master: TCP/UDP Sockets" on page 67.
• To configure the port for DF1 Full-Duplex and the network for Allen
Bradley Ethernet or Ethernet IP, see "Configure a Serial-Connected
Master: Generic Procedure" on page 66.