User`s guide

User Configuration
46 Chapter 3 Configure Network and Serial Ports
Add a User
1. Click Users > New User.
2. Enter the Username, password, and password confirmation, and click
Next.
3. Select the profile that fits the user’s environment/needs, and click Next.
4. Select the Ports to manage or the Autoconnect function if needed and
click Next.
5. Review settings and click Finish.
The Advanced tab under User allows you to set Escape characters for
Connect, Telnet, Rlogin, and Kill as well as an SSH Public Key.
6. Click Apply to save the settings.
7. Click Reboot for changes to take effect.
8. User attributes can be changed after the user is set up. Select
Users > username. From here you can change the password, the
access method, the menu, or verify the user’s properties.
Configure User Access Method
1. Set up the user as described in the previous procedure.
2. Click Users > username to assign access and select the access
method or methods.
3. Select the ports for the user and click Apply.
Change or Update User Passwords
On the Users page, you can also change or update the users password.
However, if the Admin password is lost, the only recovery is factory default
reset. See "Reset Configuration to Factory Defaults" on page 103.