User`s guide

Quick Reference for Configuring Features
20 Chapter 1 Introduction
Industrial Automation (IA):
• Protocol conversion
between Modbus, Allen-
Bradley, and ASCII device
Digi One IAP
Digi One IAP Haz
Applications > Industrial Automation >
“launch Industrial Automation Wizard”
Running the Industrial Automation Wizard is
the recommended method for initial
configuration of any IA equipment.
See the online help for the Wizard and this
web page: http://www.digi.com/applications/
industrialautomation/index.jsp.
• Allen-Bradley Ethernet-to-
Serial Bridging
Digi One IAP
Digi One IAP Haz
• Omron Hostlink Multi-Master Digi One IAP
Digi One IAP Haz
• Modbus Ethernet-to-Serial
Bridging
Digi One IA
Digi One IAP
Digi One IAP Haz
PortServer TS Family
• Custom (user-defined)
Multi-Master Protocol
Digi One IAP
Digi One IAP Haz
PortServer TS Family
IP routing All Configurable from command line only.
The commands to configure IP routing are
“set route” and “set forwarding.
MEI PortServer TS 8/16 MEI
Family
Configuration > System > MEI
(only maximum baud rate is configurable)
Configuration > Serial Ports > port >
MEI Serial Settings
Modem emulation Digi One SP
Digi One IA
PortServer TS Family
Configuration > Serial Ports > port >
Port Profile > Modem Emulation
See the Digi One and PortServer TS Family
Command Reference for modem emulation
commands.
Port buffering PortServer TS Family To enable port buffering:
Configuration > Serial Ports > port > Console
Management Profile
or
Configuration > Serial Ports > port >
Advanced Serial Settings
To display contents of a port buffer:
Management > Serial Ports > Port Logs
Port logging Digi One IAP
Digi One IAP Haz
PortServer TS Family
Configuration > Serial Ports > port >
Advanced Serial Settings > Enable Port
Logging
Port profiles All devices that support
the default Web user
interface
Configuration > Serial Ports > port >
Port Profile
Feature/Task
Digi Devices
supported in
Web User Interface Path to Feature