User`s guide

90 Chapter 11 Configuration Management
TFTP Procedure for Backup or Restore
1. Ensure that TFTP is running on the remote host.
2. Access the web interface by entering the Digi devices’s IP address in a
browser’s URL window.
3. Log on to the Digi device as root. The default password is dbps.
4. From the main menu, choose Backup/Restore > TFTP Server.
5. Enter the name of the file and the IP address of the TFTP server and
click Backup (to save the file) or Restore (to apply the file).
Resetting Configuration to Defaults
To reset the configuration to defaults, follow these steps:
Note: The reset procedure causes the Digi device to lose all configuration changes
including IP settings. If you have a complex configuration, contact Digi before
performing for information on saving your configuration. See "Reference and
Certifications" on page 91 for information.
1. Use a pen, the point of a paper clip, or some other device to press the
recessed button on the front panel. Although the object used to access
the reset button must be pointed, be sure it is not sharp or it may
damage the reset button.
2. While holding down the button, power on the Digi device.
3. When the 1-5-1 LED pattern is displayed, release the button.
Note: It may take approximately two minutes for the device to boot up.
The device boots up.