User`s guide

Chapter 1 Introduction 9
About This Guide
Purpose
This user guide provides the following:
• Configuration and administration procedures
• Configuration examples
Audience
This guide is intended for the person responsible for configuring and
administering the Digi device. It assumes that this person has experience
configuring network devices and is familiar with networking concepts.
Scope
This guide provides step-by-step instructions for configuring and
administering your Digi device’s main features. It focuses on performing
these tasks through the Web user interface. It does not address how to
configure every option, provide complete information on commands, or
discuss hardware installation. These topics are covered in other
documents in the Digi library.
Other Documents in the Library
The Digi library is a collection of documents found on the Software and
Documentation CD under Documentation. The following is a description of
the documents available on the CD.
Quick Start Guide
The guide that comes in the package with the Digi device covering the first
steps necessary to get your device up and running. UNIX mounting
instructions can be found on the back of the Quick Start Guide.
Digi Command Reference
This online manual, available on the Software and Documentation CD,
provides complete information on commands.
Cable Guide
This manual provides cabling information for connecting your peripheral
devices to the Digi device.
RealPort Setup Guides
These online manuals provide information on setting up servers for and
installing the RealPort software.
AT Command Reference
The complete reference for all the AT commands for the embedded
modem products (PortServer TS 1 M MEI and PortServer TS 3 M MEI).
Note: The Modem Emulation feature described later in this document has its own
set of AT commands that are listed in the "Modem Emulation AT Command
Set" on page 70.
Chapter 1
Introduction