User`s guide

Chapter 5 Special Features: Wireless 57
Use this chapter for the initial configuration of your Digi Wireless device.
After the initial configuration, the device can be configured using the same
methods as the other Digi TS family products.
Configuration Considerations
The Digi wireless devices work ONLY with the antennae provided. You can
use the wizard available on the Software and Documentation CD to
configure your wireless device. You will need an Ethernet cable and a
network PC to configure the wireless Digi device. After assigning the IP
address, access the device from your browser by entering the IP address
in the URL address bar.
Initial Configuration Using Ethernet
1. Connect serial cable, Ethernet cable, and power supply.
2. Insert the CD in the drive. The configuration wizard will automatically
start. Follow the steps in the wizard (either for Microsoft Windows or
Unix) to configure the device.
Or:
If you do not want to use the wizard, click Cancel and follow the
remaining procedure steps to set up the IP address and configure the
device through the web interface.
3. Select Discover Digi Device (from the CD).
4. Select the wireless device and assign the IP address.
5. Click Set IP.
6. Enter the IP address, Subnet, and Gateway mask and click OK.
Chapter 5
Special Features: Wireless