User`s guide

52 Chapter 4 IA Profiles and Procedures
5. If you want to configure the port to launch an automatic connection to
the slave, click Advanced.
6. Choose Enable Autoconnect
7. Specify the IP address of the slave.
8. Specify a TCP port to use for this connection. If this is a connection to
another device server, use 2101 as the TCP port number.
9. If you want the autoconnection to launch immediately, choose Force
DCD.
10.Choose Binary Mode.
11. If you want to enable UDP sockets (instead of TCP sockets), choose
UDP Serial, use the online help for information on completing
configuration task.
12.When you complete configuration, click Submit.
Setting Up COM Port Redirection
About These Procedures
Use these procedures when a slave is connected to the serial port of the
device server and the master, which must be an application residing on a
Microsoft Windows system, requires COM port redirection.
Setup Tasks: An Overview
To enable Com port redirection--which requires that RealPort software be
running on the same PC as the master application--complete the following
tasks:
1. Configure the serial port for RealPort.
See "Procedure: Configuring the Serial Port for RealPort" on page 53.
2. Install RealPort software on a host system.
Note: See the RealPort Installation Guide on the Digi CD under documentation.