Manualshelf

User`s guide

ManualsBrandsDigi ManualsComputer equipment34
51525354555657585960
Chapter 4 IA Profiles and Procedures 51
5. Choose Master as the Mode.
6. Configure up to 8 network slaves.
7. Change the default socket number only if required.
Configuring a Serial-Connected Slave: Other IA Protocol
About This Procedure
Use this procedure in the following situations:
• When the device connected to the serial port is a slave that is using
a “non-supported” serial-port protocol, that is, the serial port protocol
is not Modbus ASCII, Modbus RTU, DF1 Half-Duplex, DF1 Full-
Duplex, FINS, Hostlink, CompoWay/F, or a protocol that meets the
definition of a “user-defined” protocol
• When you do not
want to set up the device server for RealPort COM
Port redirection
• When multiple masters will not
be communicating with this slave
Procedure
1. Access the web interface by entering the device server IP address in a
browser’s URL window.
2. Log in to the device server as root. The default password is dbps.
3. From the main menu, choose Configure > Port.
4. From the Port configuration screen, set the Device type to Printer,
adjust other serial port communication parameters as required by the
connected slave, and click Submit.
5. Choose Advanced, check Binary Mode, and click Submit.
Configuring a Serial-Connected Master: Other IA Protocol
About This Procedure
Use this procedure when the device connected to the serial port is a
master that is using a “non-supported” serial-port protocol, that is, the serial
port protocol is not Modbus ASCII, Modbus RTU, DF1 Half-Duplex, DF1
Full-Duplex, FINS, Hostlink, CompoWay/F, or a protocol that meets the
definition of a “user-defined” protocol.
Procedure
1. Access the web interface by entering the device server IP address in a
browser’s URL window.
2. Log in to the device server as root. The default password is dbps.
3. From the main menu, choose Configure > Port.
4. From the Port configuration screen, set the Device type to Modem In,
adjust other serial port communication parameters as required by the
connected master, then choose Submit.
The Terminal type field does not matter.