User`s guide

20 Chapter 3 Configuration
Telnet port = Base Socket + Serial Port Number
Raw port = Base Socket + 100 + Serial Port Number
6. Click Apply.
7. Click Reboot for changes to take effect.
Advanced Network Settings
WARNING!!!!! changing the Advanced Network Settings could cause you to ‘lose’ your device
on the Network. If you alter these settings - you may need to reset your device with the reset
button and reconfigure your device as if it were new. See "Resetting Configuration to Defaults"
on page 90 for instructions.
****The next screen shot is for informational purposes. Digi
International recommends that you do NOT alter the Advanced Network
Settings. Be advised these settings are correct for most environments.
Configuring the Serial Ports
1. Click Serial Ports under Configuration.
Service Base Socket Network Port
telnet 2000 2001
raw (TCP or UDP) 2000 2101