User`s guide

Chapter 2 Configuring the IP Address 17
following is an example of how this is done on a Windows NT 4.0
system:
arp -s 191.168.2.2 00-00-9d-22-23-60
4. Ping the Digi device using the IP address just assigned. The following is
an example:
ping 191.168.2.2
The ping will probably time out before there is a response from the Digi
device.
5. Wait 30 seconds and then ping the Digi device again.
The Digi device replies to the ping, indicating that the IP address has
been configured.
Configuring an IP Address using DHCP and RARP
About DHCP and RARP
When the device server boots, it transmits a DHCP request and a RARP
request. This continues until an address is assigned.
Procedure
To use RARP or DHCP follow these steps:
1. Set up an entry for an address on a DHCP or RARP server. If you
intend to use RealPort, do the following:
• Reserve a permanent IP address.
• Record the IP address. You will need it when you configure the
RealPort driver.
2. Power on the device server.
The DHCP or RARP server assigns the device server an IP address.
Accessing the Digi Device
1. Enter the IP address in the URL bar of your browser.
2. Enter your login name (root) and password (dbps).
Note: The following screen appears allowing you to configure the device for your
specific needs. A tutorial is available to guide you in your decisions. The Help