Owner's Manual

26
Variable Voltage Trim Controls
The variable trim controls next to the output 9 and
10 connectors become active when these outputs are
configured for “variable” operation. When active, these
trim controls are used for supplying higher or lower
power voltage to pedals, changing the way they sound
by changing the pedal’s available headroom. Raising
the voltage can raise the headroom and provide a
cleaner tone and lowering the voltage can lower the available headroom, making a pedal
compress and distort more so than usual. The lowering of the supplied power voltage
is referred to as “voltage sag” and emulates a low battery. This is typically only applied to
overdrive, fuzz, and distortion type effect pedals and not modulation and time-based effect
pedals (as you typically want these type of effects to be as clean as possible).
WarNiNg! Not all analog pedals allow for operation at different voltages and may be damaged
if you attempt to do so. Check the pedal’s user guide or contact the pedal manufacturer to verify
whether or not the pedal can be operated at different voltages and what the safe voltage range
is. DigiTech assumes no responsibility or liability for equipment damaged by improper use of this
power supply.
1
2
3
4
9
10
9V
150 m A PWR
9V9V
9V
9V / VAR
150 m A150 m A
150 m A
9V / 12V9V / 12V
200 m A200 m A
78
MERGE
300 m A
9V / 12V9V / 12V
150 m A150 m A150 m A
9V / VAR
150 m A
6
MERGE
400 m A
5
5678910
12V12V12V12VVA R
VA R
9V9V9V9V9V9V
1 2 3 4 5 6 7 8
ON
MERGE MERGE
ISOL ISOL
OF FIRE OR
ELECTRIC
SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
TO REDUCE THE RISK
WARNING:
ELECTRIQUE - NE PAS OUVRIR
RISQUE DE CHOC
ATTENTION:
CAUTION
CAUTION
120V~60Hz
40 WATTS
N2082
®