Owner's Manual

11. Out 2 Jack
Connect this output to a second amplifier or mixer channel for stereo
flanging. Stereo is the best way to get the most effective stereo flange
experience from the Turbo Flange pedal.
Connections
The Turbo Flange has a single input and a pair of outputs. Out 1 is used if
the Turbo Flange is being connected to only one amplifier or mixer channel
with the pan set to center. Out 2 is used for stereo operation. Connect
Out 1 to the first amplifier or mixer channel panned left and Out 2 to the
second amplifier or mixer channel panned right.
The Turbo Flange also has built-in CIT™ cabinet modeling that can be
enabled. This is a useful tool when running a distortion pedal into the Turbo
Flange and then running direct into a mixer or recorder. CIT cabinet
modeling creates a guitar-through-an-amplifier sound without having to use a
guitar amp.
To Enable CIT™ Cabinet Modeling:
Press the pedal down and apply power (connect a guitar cable to the Turbo
Flange input or connect the PS200R power supply to the AC adapter jack).
CIT™ cabinet modeling has to be turned on each time you apply power to
the Turbo Flange.