Owner's Manual
6. Input Jack
Connect your instrument to this jack. Connecting a guitar cable to this jack
supplies battery power even though the Indicator LED may not be lit. To
prolong battery life, disconnect all cables from the pedal when not in use.
7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place. Push
these pins in to release the pedal from the pedal chassis exposing the
battery compartment. (See battery replacement diagram.)
8. Pedal
Press the pedal to turn the effect on and off.
9. Out 1(Mono) Jack
Connect this output to a single guitar amplifier or mixer channel when only
one amp or mixer channel is being used.
10. Indicator LED
This LED indicates when the effect is turned on. If the LED becomes dim or
does not light when the cables are connected, the battery needs to be
replaced.