Owner's Manual

Connections
The Synth Wah has a single input and a pair of outputs. When possible,
the Synth Wah should be the first effect pedal in your effects chain. This
insures proper triggering of the different effects. Out 1 Normal (Dry)
is used when the Synth Wah is connected to a single amplifier or mixer
input. When only Out 1 Normal (Dry) is used, effect signal is present
when the Synth Wah is on. If bypassed, a dry unprocessed signal is
present.
Out 2 (Effect) has effect signal only when the Synth Wah is on, and is
muted when it is bypassed. When Out 2 (Effect) is used, Out 1
Normal (Dry) becomes a dry path only when the Synth Wah effect is
on or bypassed. This allows you to mix dry guitar and synth effect
separately into two different inputs. An ideal setup is to have Out 1
Normal (Dry) connected to your guitar amp and Out 2 (Effect)
connected to a mixer channel. In this configuration, Out 1 Normal
(Dry) sends a dry, unprocessed guitar signal to your amplifier and Out
2 (Effect) sends only the effect signal to a full range system. You can
then mix guitar signal from your amp and synth effect signal from the
mixer separately for dramatic guitar/synth applications.