Owner's Manual

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to

a ﬂat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the

steps listed below.

1. Turn the amp volume all the way down.

2. Connect the plug of the included power supply to the power jack on the rear panel of the

RP70.

3. Connect the other end of the power supply to an AC outlet. Use the Master Level but-

ton and the Value Up/Down buttons to set the RP70’s Master Level to “0”.

4. Turn the power of your ampliﬁer(s) to the on position and adjust the volume(s) to a nor-

mal playing level.

5. Use the Master Level button and the Value Up/Down buttons to gradually increase the

RP70’s Master Level to achieve the desired volume.

4. Turn amp volume up

1. Turn amp volume down

2. Connect the power adapter to power jack

3. Connect the power adapter to AC outlet

and set the RP70’s Master Level to “0”

5. Set the RP70’s Master Level to the

desired listening volume