DECLARATION OF CONFORMITY Manufacturer’s Name: Manufacturer’s Address: DigiTech 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product: Warning For your protection, please read the following: Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Do not use this apparatus near water. 5. Clean only with dry cloth. conforms to the following Product Specifications: 6. Do not block any ventilation openings.
WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty. 2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service. 3.
The Main Squeeze Compressor/Sustainer is a high quality compressor using world famous dbx® dynamics processing. DigiTech’s exclusive AudioDNA™ technology gives you studio quality comression in an easy to use stompbox design. Experimenting with the Main Squeeze controls provides you a variety of application settings, from mild compression that subtly quiets peak signals, to full on sustain for squeezing the last drop out of each note during those great solos. 1. Level Knob Controls the effect’s output level.
1 2 3 4 5 11 10 9 6 7 8
3. AC Adapter Jack Connect a DigiTech PS200R power supply to this jack. Use the proper supply for your area’s Mains line voltage. 4. EQ Knob Controls the boost or cut of high frequencies. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content. 5. Sustain Knob This knob is used to set both the threshold and output gain of the compression effect.
. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push either pin in to release the pedal from the chassis, exposing the battery compartment. (See battery replacement diagram.) 8. Pedal Turns the effect on and off. 9. Out 1(Amp) Jack Connect this output to your guitar amplifier. 10. Indicator LED Indicates when the effect is turned on. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. 11.
Connections The Main Squeeze has a single input (INPUT) and a pair of outputs (AMP and MIXER). The two outputs give you the following options: running into a guitar amplifier, or running directly to a mixing console or recording device, or both. The MIXER output uses DigiTech’s advance CIT™ cabinet modeling technology for an authentic guitar amplifier sound without using an amp. Follow these setup directions: 1.Turn the volume down on the amplifier/mixer you are connecting to. 2.
Battery Replacement 1. Using the tip of a 1/4” guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. 2. Remove the battery from the battery compartment and disconnect the battery cable. 3. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. 4. Place one hole of the pedal over its corresponding pin. 5.
SPECIFICATIONS: • Controls - Level, Attack, EQ, Sustain, On/Off Pedal • Jacks - Input, Out 1 (Amp), Out 2 (Mixer) • Input Impedance - 1 MOhms • Output Impedance - 100 Ohms • Power Supply - 9V Alkaline Dry Battery • Power Consumption - 4.8Watts (w/optional PS200R power supply) • Battery Life - Approximately 4 hours (with continuous usage) • Dimensions - 4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H) • Weight - 1.38 lbs.
