Owner's Manual

33
Adding an Amp to the iPB-10 Signal Path
1. If the Pedalboard window is not already acve, select
it by touching the Pedalboard icon.
2. Touch the Edit buon to display the Edit screen.
3. Touch the
icon located in the amp eld. A window
will appear displaying all the available internal amps.
4. Select the desired amplier from the list. The matching
cabinet will be loaded with the amp.
5. Touch the Done buon.
6. To posion where the amp is located in the signal
path, touch the Amp icon and drag it to the desired
posion (this will also set the signal path locaon of
the Amp Loop, if used).
7. Once complete, touch the Performance buon to get
back to Performance mode.
1.
3.
5.
7.
6.
4.
2.
Working With AmpsWorking With Amps