Owner's Manual

Amp Loop

These 1/4” send and return jacks allow you to connect an

external preamp or amplier and use the tone from these

components instead of the internal ampliers of the iPB-10.

iPB-10 Rear PaneliPB-10 Rear Panel

Stomp Loop

These 1/4” send and return jacks

allow you to insert an external

stompbox eect pedal (or chain

of eects) into the iPB-10 signal

path.

Amp Loop Ground Lift Switch

This switch can be enabled to help prevent unwanted

hum or buzz caused by ground loops between the iPB-10

and an externally connected amplier or preamp.

NOTE: Status messages will be displayed if the AMP or STOMP footswitches are pressed and the Amp or Stomp Loop

modules are not used in the current preset Tone (unavailable), or if nothing is connected to these jacks (not connected).