DECLARATION OF CONFORMITY Manufacturer’s Name: Manufacturer’s Address: DigiTech 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product: Product name: DigiVerb Product option: all (requires Class II power adapter that conforms to the requirements of EN60065, EN60742, or equivalent.
WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty. 2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service. 3.
The DigiVerb is a powerful studio quality reverb housed in a familiar stompbox design. Seven high quality reverbs are easily accessed with the twist of a knob.You can adjust decay, change EQ, and balance the level for your particular application. You can even use the DigiVerb in an auxiliary send whenever you need that extra reverb in the mix. 1. Level Knob Controls the output level of the reverb effect.
1 2 3 4 5 11 10 9 6 7 8
3. AC Adapter Jack Connect a DigiTech PS200R power supply to this jack. Use the proper supply for your area’s Mains line voltage. 4. Decay Knob Controls the amount of reverb decay time. Turn the knob clockwise to increase the decay time and counter-clockwise to decrease the decay time. 5.Type Knob Selects one of seven different studio quality reverb types including Room, Plate, Hall, Church, Gated, Reverse, and Spring. 6. Input Jack Connect your instrument to this jack.
. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the pedal chassis exposing the battery compartment. (See battery replacement diagram.) 8. Pedal Press the pedal to turn the effect on and off. 9. Out 1(Mono) Jack Connect this output to a single guitar amplifier when only one amp is being used. 10. Indicator LED This LED lights when the effect is turned on.
Connections The DigiVerb has a single input and a pair of outputs. Out 1 is used if the DigiVerb is being connected to only one amplifier. Out 2 is used for stereo operation. Connect Out 1 to amplifier 1 or the input of a mixer channel and Out 2 to amplifier 2 or the input of another mixer channel. The Digiverb can also be connected to the effects send/return of a mixer. Connect the mixer’s effect send to the In (6) of the DigiVerb.
To Enable CIT™ Cabinet Modeling: Press the pedal down and apply power by connecting a guitar cable to the DigiVerb input or connecting the PS200R power supply to the AC adapter jack. CIT™ cabinet modeling has to be enabled each time you apply power to the DigiVerb. Battery Replacement 1. Using the tip of a 1/4” guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. 2.
Pedal Pedal Switch Arm 9V DC Battery Pedal Release Pin Battery Compartment Spring Pedal Release Pin Pedal Chassis
SPECIFICATIONS: • Controls - Level, EQ, Decay,Type, On/Off Pedal • Jacks - Input, Out 1 (Mono), Out 2 • Input Impedance - 1 MOhms • Output Impedance - 100 Ohms • Power Supply - 9V Alkaline Dry Battery • Power Consumption - 4.8Watts (w/optional PS200R power supply) • Battery Life - Approximately 4 hours (with continuous usage) • Dimensions - 4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H) • Weight - 1.38 lbs.
