Owner's Manual

Tuner
The Control 2 provides access to the host GSP’s tuner and provides tuner
feedback via the Control 2’s Display.
To tune your guitar, follow these steps:
Press the TUNER footswitch. The Control 2’s Display will briefly show
TUNER and the TUNER footswitch LED will now be lit. The guitar
signal is normally muted when the tuner is accessed. You can rock the
Expression Pedal forward to hear the note while it is being tuned.
Begin playing a note on the guitar. The leftmost characters of the Display
will show the note being played. The rest of the Display will show
arrows indicating the relative tuning. An arrow pointing to the left ( )
indicates the note is sharp and should be tuned down. An arrow pointing
to the right ( ) indicates the note is flat and should be tuned up. When
your note is in tune, is displayed.
Press any footswitch (or the Back button or the Edit/Select knob on
the GSP) to return to the preset.
Assigning Parameters to the CONTROL
Footswitch (#10)
You can set up the CONTROL footswitch to control a parameter of your
choice, including each effect’s On/Off parameter. To assign a parameter to the
CONTROL footswitch, follow these steps:
From the Preset screen on the GSP, press the Edit/Select knob twice.
Turn the Edit/Select knob to highlight Expression Links and press the
Edit/Select knob. The Edit Expression Links menu appears.
Scroll down and highlight an expression link that is not in use (NO CTRL
NO LINK). Press the Edit/Select knob to select the expression link.
The Linking menu appears.
Make sure Assign Controller is highlighted and press the Edit/Select
knob.
1.
2.
3.
1.
2.
3.
4.

Control 2 Owner’s Manual
Using the Control 2 Remote Foot Controller