User manual

8
Recording/Data Logging Operation (Meter)
1. Press Power on/off button to turn the unit on. The
first value immediately shown is the number of data
logging sample points remaining (Fig. 5).
2. Press Rec/ button to begin recording; the TYPE K
icon will be flashing to indicate the meter is recording
data measurements.
3. To stop recording, press and hold Rec/ button for
three seconds until the TYPE K icon is no longer
flashing.
4. Note: A maximum of 18,000 sample points is avail-
able (Fig. 5). As you log temperature readings, this
value will be lower each time you turn on the meter.
When the memory is full (with 0 sample points
remaining), the first value shown will be “FULL”
rather than a number. Or if you try to record, the
REC icon will flash five times and disappear. At this
point, you are no longer able to record until the
memory is cleared. (See "Changing Setup Options",
"Clear Memory Operation" on pages 6–7.)
Recording/Data Logging Operation (Software)
1. First install software on PC following the setup wizard (see “Software
Installation” on next page). Once software is successfully installed, the
data logging software icon shortcut will be automatically placed on your
PC desktop.
2. Connect meter to PC via the supplied USB cable.
3. Power the meter on.
4. Open the installed Data Logger Software by double-clicking on the icon
on your PC desktop.
5. In the Data Logger Setting menu, confirm time and select date format,
sampling rate, memory full directions, auto power-off status, and start
method, then select “OK”. You must set these parameters before meter
will record measurements.
a. Note: Manual start method is controlled by user pressing REC
button on the meter. Automatic start method will activate
recording via the software instantly once selected.
6. In manual record mode, press and hold Rec/ button on the meter for
three seconds until the TYPE K icon is flashing, indicating that recording
function has been activated. Upon completion of desired data logging of
measurements, press and hold Rec/ button for three seconds until
TYPE K icon stops flashing, indicating data logging has been deactivated.
Fig. 5. Display shows 18,000
sample points available.