User manual

Sample Rate Function

The tertiary display shows the sample rate of the

temperature data recording. When the meter is

powered on, the default sample rate is 1 second.

The tertiary display shows “00 01” in minutes, then

seconds (Fig. 2).

1. Press °C/°F/K button until the value you wish to

change is ﬂashing.

2. Press  or Rec/ button until the setting you

want to use appears on the display.

3. Press Enter button to store the new setting into

memory.

Time Setting Function

1. While in Setup mode, scroll to the time setting

option screen (Fig. 3).

2. The primary display shows the year. The second-

ary display shows the month and the day, the

tertiary display shows the hour and minute. In

Fig. 4, the display shows the date and time

“2007-3-30 16:25”. If no adjustment is needed,

press Enter button to exit time setting.

3. Set the time. The adjust order is year, month,

day, hour, minute. Press °C/°F/K button until the

value you wish to change is ﬂashing.

4. Press  or Rec/ button until the setting you

want to use appears on the display.

5. Press Enter button to store the new setting into

memory.

Clear Memory Operation

Immediately after turning on the meter, the ﬁrst

value shown is the number of data logging sample

points remaining (from 18,000 to 0). Once the

memory is full, the ﬁrst value shown will be “FULL”

rather than a number. At this point, you are no

longer able to record until the memory is cleared.

1. Press and hold Setup button for three seconds to

enter the Setup mode. While in Setup mode, the

display shows the SETUP icon.

2. Use the  and Rec/ buttons to scroll to the CLR

memory option screen. The screen indicates the

number of sample points remaining.

Fig. 2

Fig. 3

Fig. 4