User manual

Sample Rate Function

The secondary display shows the sample rate of

the temperature data recording. When the meter is

powered on, the default sample rate is 1 second.

The secondary display shows “00 01” in minutes,

then seconds (Fig. 2).

1. Press °C/°F/K button until the value you wish to

change is ﬂashing.

2. Press  or Rec/ button until the setting you

want to use appears on the display.

3. Press Enter button to store the new setting into

memory.

Time Setting Function

1. While in Setup mode, scroll to the time setting

option screen. The primary display shows the

year; the secondary display shows the month

and the day; and the tertiary display shows the

hour and minute. In Fig. 3, the display shows the

date and time “2007-08-16 18:55”. If no adjust-

ment is needed, press Enter button to exit time

setting.

2. Set the time. The adjust order is year, month,

day, hour, minute. Press °C/°F/K button until the

value you wish to change is ﬂashing.

3. Press  or Rec/ button until the setting you

want to use appears on the display.

4. Press Enter button to store the new setting into

memory.

Clear Memory Operation

Immediately after turning on the meter, the ﬁrst

value shown is the number of data logging sample

points remaining (from 10,000 to 0). Once the mem-

ory is full, the ﬁrst value shown will be “FULL”

rather than a number. At this point, you are no lon-

ger able to record until the memory is cleared.

1. Press and hold Setup button for three seconds to

enter the Setup mode. While in Setup mode, the

display shows the SETUP icon.

2. Use the  and Rec/ buttons to scroll to the CLR

memory option screen. The screen indicates the

number of sample points remaining (Fig. 4).

Fig. 2

Fig. 3

Fig. 4