User Guide

Connection Pin-out
Do not use harsh chemicals, strong detergents or cleaning solvents to clean
the device.
Cleaning
Digi-Pas® device is calibrated in the factory for maximum accuracy.
Users can re-calibrate when necessary.
for detail calibration please refer to the Instruction manual available online
Calibration
Kit Contents
Sensor module
Calibration Certificates
Quick Guide
1
2
3
Sensor DB-9
Male Cable
RS422/485
serial
converter
Female DB-9 lead cable
DESKTOP PC
Sensor module
2-Axis Precision Sensor Module
QUICK START GUIDE
DWL-4200XY / DWL-4500XY
Direct serial RS422/485 connection diagram
JQC-2-04X00-99-000
Download manual/quick guide:
Handbuch/Schnellanleitung herunterladen:
日本語のマニュアルは以下よりご確認下さい。
下载手册/快速指南:
https://www.digipas.com/manual4000xy.php
DWL-4000XY series PC sync software
up to 4 sensors can be connected through control box for silmutaionsly
DWL-4000XY Series PC Sync Software Basic Edition is available free for
download at digipas.com website.
6 7 8 9
1 53 42
Sensor DB-9 Male cable connector pin-out
GND
N.C (No Connection)
GND (without Control Box) or Signal 1 (For Control Box only)
GND (without Control Box) or Signal 2 (For Control Box only)
Power Input (Regulated 9V ~ 30 DC)
RS485 - A (Non-inverting Receiver Input/Tx+)
RS485 - B (Inverting Receiver Input/Tx-)
RS485 - Z (Inverting Driver Output)/Rx-)
RS485 - Y (Noninverting Driver Output / Rx+)
1
2
3
4
5
6
7
8
9
DescriptionPin No.
Warranty
Digi-Pas® Digital level is warranted to the original purchaser to be free from defects in
workmanship and material. JSB Tech will, at its option, repair or replace any defective part
which may malfunction under normal and proper use within a warranty period of 1 (one)
year from the date of shipment. This one-year warranty clause is NOT applicable to
European Union (EU) member states. Purchases made in EU member states will be covered
by the existing consumer laws across the European Union, which provide statutory
warranty rights in addition to the coverage of one year warranty period. The foregoing
warranty shall not apply to defects resulting from misuse, abuse, or transfer by the Buyer,
Buyer-supplied software or interfacing, or unauthorized modification or operation outside
of environmental specifications for the product. JSB Tech does not warrant that the
operation of the instrument software, or firmware, will be uninterrupted or error-free. The
exclusive remedy under any and all warrants and guarantees expressed herein, and we
shall not be liable for damages from loss or delay of equipment uses, consequential, or
incidental damage. No other warranty is expressed or implied. JSB Tech specifically
disclaims the implied warranties of merchantability and fitness for a particular purpose.
Multiple sensor connection diagram using control box
PC SYNC SOFTWARE, DRIVER & Sample Code visit:
https://www.digipas.com/pcsync4000xy.php
Technical Support
Email : [e-mail]
DC 9~30V power
adaptor to sensor
USB Connection
Technical Specification (Sensor)
Power Voltage
Output Mode
Waterproof Rating
Operating Temperature
Weight (Approx.)
Dimension (mm)
RS485 (full duplex)
9 ~ 30V DC
IP65
-40°C to +85°C
350g
67 x 42 x 23
Notes :
-
-
Product specification and appearance are subject to change for product improvement without prior notice.
Control Box is required
USB, RS232, and SPDT Relay.
Wireless Bluetooth connectivity (optional)
DESKTOP PC
Sensors module
DC 12V power
adaptor
Control
Box
42 mm
1.65”
23 mm
0.9”
67 mm
2.64”
Wire Length (Approx.) 3 Meter or 3.28 ft
Note:
Sample code are only available in C# language and can be compile through Microsoft
Visual Studio.