Instruction Manual

When display alarm 1 or alarm 2, press and hold MODE button to enter into setting mode.
The hours will blink on the display. Set the hours by pressing +/AIR PRESSURE
or
-/MAX/MINand confirm your setting by pressing MODE button. Set the minutes in the
same way.
Alarm on/off
 Alarm 1 on/ off
At standard displaying mode, press MODE to switch to alarm 1 display mode. Then you
will see
iconflashandalarmon/offstatusontheseconddispayarea.Press+/AIR
PRESSUREor-/MAX/MINto turn on/off alarm 1. When it is set to be on, after exit, alarm 1
 willbedisplayontheLCD.

 Alarm 2 on/ off
At standard displaying mode, press MODE to switch to alarm 2 display mode. Then you
will see
iconflashesandalarmon/offstatusontheseconddispayarea.Press+/AIR
PRESSUREor
-/MAX/MINto turn on/off alarm 2. When it is set to be on, after exit, alarm 2
 willbedisplayontheLCD.

Relative/absolute air pressure
At normal display mode, press +/AIR PRESSUREto swtich bewtween relative air pressure
and absolute air pressure

Temperatureunit ℃ and℉selection
Hold MODE 2 seconds, the ℃ flashes, press  +/AIR PRESSUREor-/MAX/MIN to
select ℃ or ℉.
Activating reception from the outdoor sensor
The outdoor sensor will transmit a signal about twice a minute,which is automatically
received by the base station. However,you may also manually activate reception of the
signal.To do so,press and hold the CHANNEL button for three seconds until the channel
symbol
flashes.Following successful reception the animation of the symbol will
disappear and the transmitted temperature and humidity will appear in the display.