Instruction Manual
Temperature accuracy: +/-2 C at 40C-60C, -20C~10C
Battery operation
1.Open the battery cover at the back of the base station insert3 XAAA batteries
2.When changing batteries first remove the old batteries.Insert the new batteries,type
LR03,in the battery compartment.check the polarity of the battery during the insertion.this
is indicated in the battery compartment.
3.Close the battery cover.
Starting the base station
After insert batteries, The display will briefly light up and run a brief check of all display
elements.
1. The weather icon will flash,you can press
-/MAX/MIN/- or+/AIR PRESSURE to adjust,
press HISTORY/WEATHER to confirm
2. The outdoor temperature field will show an animation of reception symbol
,indicating the base station is searching for the signal from the outdoor sensor.
2.If no outdoor temperature is displayed after 3 minutes,the base station will stop
searching,the animation of the reception symbol will turn off and the outdoor temperature
field will show--.-℃
3.Most likely ,the signal cannot be received due to structural factors,reinforced concrete
walls,the brick work being too solid or the distance between the units.After finding the
better location for the outdoor sensor ,reception will need to be restarted.
4.3minutes later ,then the weather station will automatically start receiving the DCF radio
signal ,regardless if signal from the outdoor sensor was received or not.The clockwill show
an animated radio tower icon
,indicating the receiver for the DCF signal is start to
received the time.
5.If the signal is detected the clock displaywill show the current central European
time,date and day of the week.A static radio tower signal appears.
6.If the attempts of receive a signal fail the base station will stop attempting to receive a
signal after10 minutes and the radio tower signal will disappear.
7.You may reactivate reception by press and holding the
-/MAX/MINbutton for three
seconds until an radio tower signal in the clock displaybecomes animated.you also have
the option to set the time manually.
8. HOLD +/AIR PRESSUREand
-/MAX/MIN to exit RCC function. Then displayonthe
LCD.HOLD +/AIR PRESSUREand
-/MAX/MIN again to turn on RCC.