User`s manual

92 rabbit.com Index
macros, defined internally
__SEPARATE_INST_DATA__ .........................40
_BOARD_TYPE_ ...............................................40
_CPU_ID_ ...........................................................40
_FLASH_ ............................................................40
_FLASH_SIZE_ ..................................................40
_RAM_ ................................................................40
_RAM_SIZE_ .....................................................40
CC_VER ..............................................................40
MAX_USERBLOCK_SIZE ...................................64
MB0CR_INVRT_A18 ............................................43
MB0CR_INVRT_A19 ............................................43
MBxCR ...................................................................38
MECR .....................................................................38
memory
access time ...........................................................16
bank control registers ..........................................38
data segment logical address ...............................41
flash available ................................................42, 64
line permutation ...................................................17
organization .........................................................23
RAM available ....................................................42
segment locations ................................................38
MMIDR register ......................................................38
MMU/MIU ..............................................................21
N
NUM_FLASH_WAITST ........................................42
NUM_RAM_WAITST ...........................................42
O
operating voltages .............................................11, 75
org ...........................................................................48
origin directives .......................................................43
in user code ..........................................................54
oscillator ..................................................9, 10, 13, 81
output enable .............................................................9
P
periodic interrupt ...............................................76, 77
power consumption ...........................................11, 73
programming cable .......................8, 9, 19, 21, 22, 82
programming cable connector .................................10
Q
quadrant size ...........................................................38
R
RAM
access time ...........................................................41
wrap-around test ..................................................22
RAM_SIZE .............................................................42
rcodorg ....................................................................48
rconorg .................................................................... 48
Realtek Ethernet chip ..............................................78
reset ................................................................... 22, 82
rvarorg ..................................................................... 48
S
SEGSIZE register ................................................... 38
serial port A .............................................................. 9
sleepy mode
enter and exit ....................................................... 77
interrupts ............................................................. 77
SMODE pins ..................................................... 21, 82
SP register ............................................................... 38
STACKSEG register ............................................... 38
static variables ......................................................... 34
surface-mount ......................................................... 12
System ID block ................................................ 40, 57
reading ................................................................. 60
sizes of ................................................................ 60
writing ................................................................. 63
T
target communications protocol .............................. 22
through-hole ............................................................ 12
triplets ............................................................... 21, 83
troubleshooting tips ................................................. 81
U
USE_TIMER_PRESCALE .................................... 42
User block ............................................................... 57
reading ................................................................. 65
sizes of ................................................................ 60
writing ................................................................. 67
V
variables
static .................................................................... 34
W
wait states ....................................................16, 21, 42
watch expressions ................................................... 42
WATCHCODESIZE .............................................. 42
wcodorg .................................................................. 48
write enable ...............................................................9
write method ........................................................... 22
X
xcodorg ................................................................... 48
xconorg ................................................................... 48
xmemorg ................................................................. 48
xvarorg .............................................................. 48, 50