User manual

Remote Control
R&S
®
RTO
767User Manual 1316.0827.02 ─ 06
SYSTem:COMMunicate:PRINter:ENUMerate[:NEXT]?
Queries the name of the next printer installed under Windows.
The SYSTem:COMMunicate:PRINter:ENUMerate:FIRSt command should be sent
previously to return to the beginning of the printer list and query the name of the first
printer.
Return values:
<PrinterName> After all available printer names have been returned, an empty
string enclosed by quotation marks (") is returned for the next
query. Further queries are answered by a query error.
Usage: Query only
SYSTem:COMMunicate:PRINter:SELect<1..2> <PrinterName>
Selects a configured printer.
Parameters:
<PrinterName>
Enter the string as it is returned with SYSTem:COMMunicate:
PRINter:ENUMerate:FIRSt or SYSTem:COMMunicate:
PRINter:ENUMerate[:NEXT].
16.2.17 General Instrument Setup
This chapter describes commands related to SETUP > "System" and "File" > "Exit". For
commands related to SETUP > "Remote Settings", see chapter 16.2.4, "General Remote
Settings", on page 426.
SYSTem:EXIT...............................................................................................................767
SYSTem:DATE..............................................................................................................768
SYSTem:TIME...............................................................................................................768
SYSTem:DEVice:ID.......................................................................................................768
DIAGnostic:SERVice:FWVersion.....................................................................................768
DIAGnostic:SERVice:COMPutername..............................................................................768
DIAGnostic:SERVice:PARTnumber.................................................................................769
DIAGnostic:SERVice:SERialnumber................................................................................769
SYSTem:VERSion.........................................................................................................769
SYSTem:DFPRint..........................................................................................................769
SYSTem:ERRor:ALL......................................................................................................769
SYSTem:ERRor[:NEXT].................................................................................................770
SYSTem:ERRor:CODE:ALL............................................................................................770
SYSTem:ERRor:CODE[:NEXT].......................................................................................770
SYSTem:ERRor:COUNt.................................................................................................771
SYSTem:EXIT
Starts the shutdown of the firmware.
Usage:
Event
Command Reference