User manual

Remote Control
R&S
®
RTO
762User Manual 1316.0827.02 ─ 06
EXPort:WAVeform:MEAS <MeasGate>
Sets the gate to be used for limited data export if EXPort:WAVeform:SCOPe is set to
GATE.
Parameters:
<MeasGate> MEAS1 | MEAS2 | MEAS3 | MEAS4 | MEAS5 | MEAS6 | MEAS7 |
MEAS8 | IMEAS
Measurement for which the gate is defined.
*RST: MEAS1
Firmware/Software: V 1.25
EXPort:
WAVeform:DLOGging <DataLogging>
Enables the export of several subsequent waveforms into one file.
If the history is enabled with CHANnel<m>[:WAVeform<n>]:HISTory[:STATe], the
waveforms are taken from the history. To save one waveform out of the history, specify
it with CHANnel<m>[:WAVeform<n>]:HISTory:CURRent. To save a number of sub-
sequent history waveforms, specify the range with CHANnel<m>[:WAVeform<n>]:
HISTory:STARt and CHANnel<m>[:WAVeform<n>]:HISTory:STOP.
If the history is disabled, a limited number of waveforms is transferred to file directly during
RUN Nx SINGLE acquisition. Set the number of acquisitions to be acquired and stored
with ACQuire:COUNt.
Parameters:
<DataLogging> ON | OFF
*RST: OFF
Firmware/Software: V 1.25
EXPort:WAVeform:NAME <Path>
Stes the file name and path to save the waveform to.
Parameters:
<Path> String with path and file name
Firmware/Software: V 1.25
EXPort:WAVeform:SAVE
Saves the waveform(s) to the file specified with EXPort:WAVeform:NAME
on page 762.
Usage:
Event
Firmware/Software: V 1.25
Command Reference