User manual

Remote Control
R&S
®
RTO
760User Manual 1316.0827.02 ─ 06
EXPort:WAVeform:STOP................................................................................................761
EXPort:WAVeform:ZOOM...............................................................................................761
EXPort:WAVeform:CURSorset........................................................................................761
EXPort:WAVeform:MEAS...............................................................................................762
EXPort:WAVeform:DLOGging.........................................................................................762
EXPort:WAVeform:NAME...............................................................................................762
EXPort:WAVeform:SAVE................................................................................................762
EXPort:WAVeform:SOURce <Source>
Selects the source waveform from the active waveforms of input channels, math signals
and reference waveforms.
Parameters:
<Source> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
*RST: C1W1
Firmware/Software: V 1.25
EXPort:WAVeform:SCOPe <Scope>
Defines the part of the waveform record that has to be stored.
Parameters:
<Scope> WFM | ZOOM | CURSor | GATE | MANual
WFM
Complete waveform
ZOOM
Data included in the zoom area if a zoom is defined for the source
waveform.
CURSor
Data between the cursor lines if a cursor measurement is defined
for the source waveform.
GATE
data included in the measurement gate if a gated measurement is
defined for the source waveform.
MANual
Saves the data between user-defined start and stop values to be
set with EXPort:WAVeform:STARt and EXPort:WAVeform:
STOP.
*RST:
WFM
Firmware/Software: V 1.25
Command Reference