User manual

Remote Control
R&S
®
RTO
752User Manual 1316.0827.02 ─ 06
Parameters:
<Width> Range: 100E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger<m>:PARallel:PATTern:WIDTh:DELTa <WidthDelta>
Defines a range around the width value set with TRIGger<m>:PARallel:PATTern:
WIDTh[:WIDTh].
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<WidthDelta> Range: 0 to 432
Increment: 500E-12
*RST: 0
Default unit: s
Serial Pattern Trigger
See also:
● TRIGger<m>:PARallel:SPATtern:CSOurce[:VALue] on page 744
● TRIGger<m>:PARallel:SPATtern:EXPRession[:DEFine] on page 744
TRIGger<m>:PARallel:SPATtern:CSOurce:EDGE <ClockEdge>
Sets the edge of the clock signal. The bit value is determined at the crossing of the clock
edge and the logical threshold.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<ClockEdge> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger<m>:PARallel:SPATtern:PATTern <Pattern>
Defines the serial bit string on which to trigger.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Command Reference