User manual

Remote Control
R&S
®
RTO
750User Manual 1316.0827.02 ─ 06
TRIGger<m>:PARallel:PATTern:MODE <Mode>
Sets the mode of the timing condition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Mode> OFF | TIMeout | WIDTh
OFF
No timing condition, only the logical pattern condition is relevant.
TIMeout
Defines a minimum time qualification to avoid triggering on unsta-
ble or transitional conditions. Use TRIGger<m>:PARallel:
PATTern:TIMeout:MODE and TRIGger<m>:PARallel:
PATTern:TIMeout[:TIME] to specify the timeout.
WIDTh
Sets a pulse width as timing condition. The pulse starts when the
pattern comes true, and the trigger event occurs when the pattern
comes false during the specified time limit. Use TRIGger<m>:
PARallel:PATTern:WIDTh:RANGe, TRIGger<m>:
PARallel:PATTern:WIDTh[:WIDTh], and TRIGger<m>:
PARallel:PATTern:WIDTh:DELTa to specify the width.
*RST:
OFF
TRIGger<m>:PARallel:PATTern:TIMeout:MODE <TimeoutMode>
Sets the state condition for the timeout qualification if TRIGger<m>:PARallel:
PATTern:MODE is set to TIMeout. To set the time limit, use TRIGger<m>:PARallel:
PATTern:TIMeout[:TIME].
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<TimeoutMode> HIGH | LOW | EITHer
HIGH: The pattern stays true for the specified time.
LOW: The pattern stays false for the specified time.
EITHER: The pattern remains unchanged for the specified time.
*RST: HIGH
TRIGger<m>:PARallel:PATTern:TIMeout[:TIME] <Time>
Defines the time limit for the timeout at which the instrument triggers.
Command Reference