User manual

Remote Control
R&S
®
RTO
745User Manual 1316.0827.02 ─ 06
TRIGger<m>:PARallel:EDGE:SLOPe <Slope>
Defines the edge - the state transition - of the signal to trigger on a single digital channel
(a logic bit), or a logical combination of digital channels.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
Width Trigger
See also:
● TRIGger<m>:PARallel:WIDTh:EXPRession[:DEFine] on page 744
TRIGger<m>:PARallel:WIDTh:POLarity............................................................................745
TRIGger<m>:PARallel:WIDTh:RANGe.............................................................................745
TRIGger<m>:PARallel:WIDTh:WIDTh..............................................................................746
TRIGger<m>:PARallel:WIDTh:DELTa..............................................................................746
TRIGger<m>:PARallel:WIDTh:POLarity <Polarity>
Sets the polarity of a pulse. When triggering on a positive pulse, the trigger event occurs
on the high to low transition of the pulse if the timing condition is true. When triggering
on a negative pulse, the trigger event occurs on the low to high transition of the pulse if
the timing condition is true.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Polarity> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger<m>:PARallel:WIDTh:RANGe <RangeMode>
Selects how the range of a pulse width is defined:
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Command Reference