User manual

Remote Control
R&S
®
RTO
743User Manual 1316.0827.02 ─ 06
TRIGger<m>:PARallel:SPATtern:CSOurce[:VALue]..........................................................744
TRIGger<m>:PARallel:EDGE:EXPRession[:DEFine].........................................................744
TRIGger<m>:PARallel:WIDTh:EXPRession[:DEFine]........................................................744
TRIGger<m>:PARallel:TIMeout:EXPRession[:DEFine].......................................................744
TRIGger<m>:PARallel:STATe:EXPRession[:DEFine]........................................................744
TRIGger<m>:PARallel:PATTern:EXPRession[:DEFine]......................................................744
TRIGger<m>:PARallel:SPATtern:EXPRession[:DEFine]....................................................744
TRIGger<m>:SOURce <SourceDetailed>
Selects the source of the trigger signal.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<SourceDetailed> CHANnel1 | CHANnel2 | CHANnel3 | CHANnel4 | EXTernanalog |
SBUS | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 |
D12 | D13 | D14 | D15 | LOGIC | MSOB1 | MSOB2 | MSOB3 |
MSOB4
CHANnel1...4
Input channels
EXTernanalog
External analog signal connected to the External Trigger Input on
the rear panel. For this source, only the analog edge trigger is
available.
SBUS
Serial bus
D0...D15
Digital channels (option R&S RTO-B1)
LOGIc
Logic combination of digital channels, used as trigger source
(option R&S RTO-B1)
MSOB1 | MSOB2 | MSOB3 | MSOB4
Parallel bus (option R&S RTO-B1)
*RST:
CHANnel1
TRIGger<m>:PARallel:TYPE <Type>
Selects the trigger type to trigger on digital channels and parallel buses.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Command Reference