User manual

Remote Control
R&S
®
RTO
742User Manual 1316.0827.02 ─ 06
Parameters:
<ClockSource> D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 |
D13 | D14 | D15
Clock channel
*RST: D1
Firmware/Software: V 1.30
BUS<m>:PARallel:CLEar
Removes all assigned digital channels from the bus
Suffix:
<m>
.
1..4
Selects the parallel bus.
Usage: Event
Firmware/Software: V 1.30
BUS<m>:PARallel:THCoupling <LevelCoupling>
Sets the threshold for all digital channels to the same value. Also the hysteresis value is
applied to all digital channels.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<LevelCoupling> ON | OFF
*RST: ON
Firmware/Software: V 1.30
16.2.15.3 Trigger
● General Commands..............................................................................................742
● Edge Trigger.........................................................................................................744
● Width Trigger.........................................................................................................745
● Timeout Trigger.....................................................................................................747
● Data2Clock Trigger...............................................................................................747
● State Trigger.........................................................................................................748
● Pattern Trigger......................................................................................................749
● Serial Pattern Trigger............................................................................................752
General Commands
TRIGger<m>:SOURce....................................................................................................743
TRIGger<m>:PARallel:TYPE...........................................................................................743
TRIGger<m>:PARallel:DATatoclock:CSOurce[:VALue]......................................................744
TRIGger<m>:PARallel:STATe:CSOurce:VALue................................................................744
Command Reference