User manual

Remote Control
R&S
®
RTO
741User Manual 1316.0827.02 ─ 06
Parameters:
<ShowDigitalSigns> ON | OFF
*RST: OFF
Firmware/Software: V 1.30
BUS<m>:PARallel:DISPlay:SHBU <ShowBus>
Shows or hides the indicated parallel bus. If enabled, the resulting bus signal and bus
values are displayed in the diagram.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<ShowBus> ON | OFF
*RST: OFF
Firmware/Software: V 1.30
BUS<m>:PARallel:DISPlay:BTYP <BusRepresentation>
Selects the display type of the indicated parallel bus.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<BusRepresentation> COMB | ANALog
COMB
Displays the decoded bus signal with bus values.
ANALog
Displays the bus value as amplitude, similar to an analog wave-
form.
*RST: COMB
Firmware/Software: V 1.30
BUS<m>:PARallel:CLOCk <ClockSource>
Selects the digital channel used as clock of the indicated parallel bus.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Command Reference