User manual

Remote Control
R&S
®
RTO
740User Manual 1316.0827.02 ─ 06
BUS<m>:PARallel:STATe...............................................................................................740
BUS<m>:PARallel:BIT<n>..............................................................................................740
BUS<m>:PARallel:DISPlay:SHDI.....................................................................................740
BUS<m>:PARallel:DISPlay:SHBU...................................................................................741
BUS<m>:PARallel:DISPlay:BTYP....................................................................................741
BUS<m>:PARallel:CLOCk..............................................................................................741
BUS<m>:PARallel:CLEar................................................................................................742
BUS<m>:PARallel:THCoupling........................................................................................742
BUS<m>:PARallel:STATe <Enable>
Enables the indicated parallel bus.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<Enable> ON | OFF
*RST: OFF
Firmware/Software: V 1.30
BUS<m>:PARallel:BIT<n> <Assigned>
Assigns the selected digital channel to the indicated bus.
Suffix:
<m>
.
1..4
Selects the parallel bus.
<n> 0..15
Selects the digital channel. Each digital channel provides a definite
bit of the bus word.
Parameters:
<Assigned> ON | OFF
*RST: OFF
Firmware/Software: V 1.30
BUS<m>:PARallel:DISPlay:SHDI <ShowDigitalSigns>
If enabled, the selected digital signals are shown in the diagram. Each signal is shown
its own line.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Command Reference