User manual

Remote Control
R&S
®
RTO
727User Manual 1316.0827.02 ─ 06
Parameters:
<PayloadLengthTo> Range: 0 to 127
Increment: 1
*RST: 0
TRIGger<m>:FLXRay:CENable <CycleCount>
Sets the operator to define a cycle count or a cycle count range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<CycleCount> OFF | EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
OFF
The cycle count is not relevant for the trigger condition.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one cycle count
number to be set with TRIGger<m>:FLXRay:CMIN.
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with TRIGger<m>:FLXRay:CMIN and TRIGger<m>:
FLXRay:CMAX.
*RST:
OFF
TRIGger<m>:FLXRay:CMIN <CycleCount>
Specifies a cycle count - the number of the current FlexRay cycle - or sets the the start
value of an cycle count range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<CycleCount> Range: 0 to 63
Increment: 1
*RST: 0
TRIGger<m>:FLXRay:CMAX <CycleCountTo>
Sets the the end value of a cycle count range if the condition TRIGger<m>:FLXRay:
CENable on page 727 is set to INRange or OORange.
Command Reference