User manual

Remote Control
R&S
®
RTO
725User Manual 1316.0827.02 ─ 06
TRIGger<m>:FLXRay:FCONdition <IdentifierOperator>
Sets the operator to set a frame ID or a frame ID range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<IdentifierOperator> OFF | EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
OFF
The frame ID is not relevant for the trigger condition.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one frame ID to
be set with TRIGger<m>:FLXRay:FMIN.
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with TRIGger<m>:FLXRay:FMIN and TRIGger<m>:
FLXRay:FMAX.
*RST:
EQUal
TRIGger<m>:FLXRay:FMIN <IdPattern>
Specifies a frame identifier pattern - the number of the slot - or sets the the start value of
an identifier range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<IdPattern>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421.
TRIGger<m>:FLXRay:FMAX <IdPatternTo>
Sets the the end value of an identifier range if the condition TRIGger<m>:FLXRay:
FCONdition is set to INRange or OORange.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<IdPatternTo>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421.
Command Reference