User manual

Remote Control
R&S
®
RTO
723User Manual 1316.0827.02 ─ 06
Parameters:
<Type> STOF | IDDT | SYMBol | ERRC
STOF
STart Of Frame: triggers on the first rising edge after the trans-
mission start sequence (TSS).
IDDT
IDentifier and DaTa: triggers on the decoded frame content, on
header and payload data.
For all settings that are not needed for the trigger condition, make
sure to set its condition to OFF.
Indicator bits: see TRIGger<m>:FLXRay:NUFRame
Frame identifier: sets the trigger to one specific frame ID or an
identifier range. To set the identifier, use TRIGger<m>:
FLXRay:FCONdition, TRIGger<m>:FLXRay:FMIN, and 
TRIGger<m>:FLXRay:FMAX.
Payload length: trigger on the number of words in the payload
segment. To set the payload length, use TRIGger<m>:
FLXRay:PCONdition, TRIGger<m>:FLXRay:PMIN, and 
TRIGger<m>:FLXRay:PMAX.
Cycle count: trigger on the number of the current FlexRay cycle.
To set the cycle count, use TRIGger<m>:FLXRay:CENable, 
TRIGger<m>:FLXRay:CMIN, TRIGger<m>:FLXRay:CMAX,
and TRIGger<m>:FLXRay:CSTep.
Data position: sets the position of the data bit pattern within the
payload segment. To set the data position, use TRIGger<m>:
FLXRay:DPOPerator, TRIGger<m>:FLXRay:DPOSition,
and TRIGger<m>:FLXRay:DPTO.
Data bit pattern: sets the data bit pattern to be found in the payload
segment. The starting point of the pattern is defined by the data
position. To set the bit pattern, use TRIGger<m>:FLXRay:
DCONdition, TRIGger<m>:FLXRay:DMIN, and 
TRIGger<m>:FLXRay:DMAX.
SYMBol
Triggers on a symbol or wakeup pattern. Set the required symbol
with TRIGger<m>:FLXRay:SYMBol
ERRC
ERRor Condition: triggers on one or more errors that are detected
in the decoded data. Use TRIGger<m>:FLXRay:BSSerror, 
TRIGger<m>:FLXRay:FESerror, TRIGger<m>:FLXRay:
FSSerror, and TRIGger<m>:FLXRay:PCRCerror.
*RST:
STOF
TRIGger<m>:FLXRay:PLPReamble <PayloadPreamble>
Triggers on the payload preamble indicator bit that indicates a Network Management
Vector in the payload segment.
Command Reference