User manual

Remote Control
R&S
®
RTO
710User Manual 1316.0827.02 ─ 06
TRIGger<m>:LIN:CRCDatalen <CRCDataLength>
Sets the number of data bytes to trigger on CRC errors (TRIGger<m>:LIN:TYPE is set
to ERRC and TRIGger<m>:LIN:CHKSerror is set ON.)
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<CRCDataLength> Range: 0 to 8
Increment: 1
*RST: 0
TRIGger<m>:LIN:STANdard <ChecksumStandard>
Sets the LIN standard to trigger on CRC errors (TRIGger<m>:LIN:TYPE is set to ERRC
and TRIGger<m>:LIN:CHKSerror is set ON.)
See also: "LIN standard" on page 299.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<ChecksumStandard>V1X | V2X | J2602 | AUTO
*RST: AUTO
LIN Decoding Results
BUS<m>:LIN:FCOunt.....................................................................................................710
BUS<m>:LIN:FRAMe<n>:STATus...................................................................................711
BUS<m>:LIN:FRAMe<n>:STARt.....................................................................................711
BUS<m>:LIN:FRAMe<n>:STOP......................................................................................711
BUS<m>:LIN:FRAMe<n>:VERSion..................................................................................712
BUS<m>:LIN:FRAMe<n>:DATA......................................................................................712
BUS<m>:LIN:FRAMe<n>:IDSTate...................................................................................712
BUS<m>:LIN:FRAMe<n>:IDValue...................................................................................713
BUS<m>:LIN:FRAMe<n>:IDPValue.................................................................................713
BUS<m>:LIN:FRAMe<n>:SYSTate..................................................................................714
BUS<m>:LIN:FRAMe<n>:CSSTate..................................................................................714
BUS<m>:LIN:FRAMe<n>:CSValue..................................................................................715
BUS<m>:LIN:FRAMe<n>:BYTE<o>:STATe......................................................................715
BUS<m>:LIN:FRAMe<n>:BYTE<o>:VALue......................................................................716
BUS<m>:LIN:FCOunt?
Returns the number of decoded frames.
Command Reference