User manual

Remote Control
R&S
®
RTO
709User Manual 1316.0827.02 ─ 06
TRIGger<m>:LIN:IPERror <IdParityError>
Triggers if an error occurs in the identifier parity bits. These are the bits 6 and 7 of the
identifier.
The trigger type has to be set before: TRIGger<m>:LIN:TYPE to ERRC.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<IdParityError> ON | OFF
*RST: ON
TRIGger<m>:LIN:CHKSerror <ChecksumError>
Triggers on checksum errors according to the LIN standard set with BUS<m>:LIN:
STANdard.
The trigger type has to be set before: TRIGger<m>:LIN:TYPE to ERRC.
The frame identifier must be set with TRIGger<m>:LIN:ERRPattern on page 709
and the data length with TRIGger<m>:LIN:CRCDatalen on page 710.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<ChecksumError> ON | OFF
*RST: ON
TRIGger<m>:LIN:ERRPattern <ErrorPattern>
Sets the frame identifier to trigger on a checksum error with TRIGger<m>:LIN:
CHKSerror on page 709.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<ErrorPattern>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421.
Firmware/Software: V 1.25
Command Reference