User manual

Remote Control
R&S
®
RTO
708User Manual 1316.0827.02 ─ 06
Parameters:
<WordCount> Range: 1 to 8
Increment: 1
*RST: 1
TRIGger<m>:LIN:IDOR<n>:ENABle <UseIdentifier>
Includes the indicated IDOR address in the "identifier OR" trigger condition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
<n> 1..4
Index of the identifier in an "identifier OR" condition
Parameters:
<UseIdentifier> ON | OFF
*RST: OFF
Firmware/Software: V 1.25
TRIGger<m>:LIN:IDOR<n>[:VALue] <IdentifierPattern>
Defines the pattern of the indicated IDOR identifier in the "identifier OR" trigger condition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
<n> 1..4
Index of the identifier in an "identifier OR" condition
Parameters:
<IdentifierPattern>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421. The parameter accepts the bit value X
(don't care).
Firmware/Software: V 1.25
TRIGger<m>:LIN:SYERror <SyncError>
Triggers if a synchronization error occurs.
The trigger type has to be set before: TRIGger<m>:LIN:TYPE to ERRC.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<SyncError> ON | OFF
*RST: ON
Command Reference